Where is the future development of automotive stamping dies?

Automotive stamping dies are mainly used for the efficient and mass production of automotive bodywork metal products and parts. It is one of the important factors influencing the popularization and popularity of automobiles. The advancement of automotive stamping die technology has also affected everyone’s life. About 60% to 80% of the products in the automotive, electronics, and home appliance industries are assembled after molds are molded.

With the increasing demand in the global automotive market, the demand for automotive stamping dies has also risen sharply. An ordinary car needs more than 1,000 to 1,500 sets of stamping dies in the production process. Therefore, automotive stamping dies are important process equipment for automobile production of major automotive manufacturers. Because automotive stamping dies have features such as large dimensions, complicated work profiles, and high technical standards, they are technology-intensive products. Its design and manufacturing time also account for about two-thirds of the automotive development cycle. Therefore, to improve the development and design capabilities of automotive stamping dies, to shorten the processing and manufacturing time, and ultimately to shorten the cycle of new automotive products for manufacturers, has always been the service tenet of Gree Daikin.

The traditional automotive stamping die design generally adopts single-step die and compound die structure. With the development of technology and the improvement of production equipment, the structure of multi-position die and progressive die is widely used in die design and manufacture. Therefore, on the road to the future development of automotive stamping dies, only the introduction of such structural designs with higher production efficiencies and lower production costs will make a difference in the market.

In the domestic auto stamping mold processing market, the low-end molds are relatively saturated, and the gaps in high-end molds are still very large. Most domestic high-end molds rely on processing by foreign manufacturers.